A typical compressor installation has a compressor, aftercooler, dryer, filter(s) and a receiver (airtank). All draining points can now be electronically controlled by one unit, the JORC TEC55.

This multi-voltage sequential controller can drain up to four outlets. The individual cycle requirements, as well as the overall time cycle, can be adjusted according to your specific requirements.

JORC offers a range of valves specifically designed for filters, general purpose, high pressure or stainless steel. All types can be connected to any of the 4 outlets of the JORC TEC55.

FEATURES:

• Fully wired up ready for fast efficient installation
• Centralised control of all drainage point
• CE tested
• Fully automatic - no maintenance
  
• IP65 enclosure
• Multi-voltage 115 or 230VAC 50/60Hz
• Full selection of valves available
• Fully programmable cycle times
  
• LED indicators
• ABS housing
• Solid-state electronics for long life and durability
• Load capacity 2 Amp., 40 Watt per drain.

Failure to carry out regular routine draining, either manually or by float draining can have catastrophic results. Compressed air systems can become grossly contaminated and production schedules seriously disrupted - just because a simple duty has been neglected.